RE: MILO and linload.exe

["Bruce Embrey" <bembrey earthlink net>]

Well, on my UDB I have ARC console which you can create multiple boot
selections. During your installation you should have created a DOS partition
about 2MB in size.  The command to place your milo disk into this partition
is : dd if=/dev/fd0 of=/dev/sda1 bs=1440k .

This assumes your 2MB partition is /dev/sda1 change as is appropriate for
your configuration. Make the changes to ARC or AlphaBios to reflect the
location of MILO.

Hope this helps.

Bruce

-----Original Message-----
From:	Tom Browder [mailto:tom2@fwb.asi.srs.com]
Sent:	Wednesday, September 30, 1998 12:31 PM
To:	AXP LIST
Subject:	MILO and linload.exe

All the docs I have seen have described in intimate detail how
to use a new milo and linload.exe from a boot floppy, but how
does one get them into the NT load partion for subsequent normal
boots?

Do I mount the floppy and cp to the NT partition? Or?

Thanks.

Tom Browder



--
To unsubscribe: send e-mail to axp-list-request@redhat.com with
'unsubscribe' as the subject.  Do not send it to axp-list@redhat.com