Re: Jensen Installation!!!

[Tom Everett <teverett home com>]

Two things:

1) If anyone has any additions or corrections to the install instructions
at khubla.com, pls drop me mail and I'll include them in the document.

2) I installed networking (DHCP), but I don't have the machine on the
network yet.  In case anyone else has the problem I do (machine never
seems to time out
    bringing up eth0), I used this command line to get the machine into
single user mode (from aboot)

"0/a root=/dev/sdc6 single"

I'll try to get this all up on the page ASAP



"Jaswinder S. Ahluwalia" wrote:

> First off, congrats to all those who finally got the red hat installer
> loaded!!!!!!!!!!!
>
> I myself followed the procedure at Khubla.com and got the installer to
> load. But before i did recieve an error message. Should i be alarmed by
> this?
>
> aboot: Linux/alpha SRM bootloader version 0.5
> aboot: Switching to OSF/1 Palcode version 1.35
> aboot: valid disk label found 8 partitions
> aboot: booted_dev = 'scsi 1 6 0 0 0 0  jens-io', guessing boot_device
> ='scd0'
> aboot: ext2_init: bad magic 0x0
> aboot: mount of partition 1 failed
> aboot: mount of partition 1 failed
>
> Note: after typing 0/a load_ramdisk=1 root=/dev/fd0 i am prompted for
> the ramdisk and the installer does load. Should i be alarmed by the
> above error message.
>
> Again, Congratulations!!!!!!!!!!!! :-)
>
> Thanks everyone,
> jas
>
> --
> To unsubscribe: send e-mail to axp-list-request@redhat.com with
> 'unsubscribe' as the subject.  Do not send it to axp-list@redhat.com