Re: Jensen boot question/problem

[Jo Schambach <jschamba physics utexas edu>]

I am slowly edging towards a working system. After my last post, I
figured out that I am able to boot single user by using the following
response to the aboot prompt:

0/2.2.12.gz root=/dev/sda4 single

and I finally got a bash shell.
According to Sebastian Moellers instructions, I downloaded the
system.map-2.2.12 and the libmod-2.2.12.tar.bz2 files from his ftp site,
put them onto a floppy, mounted the floppy from the bash shell, and
copied them into their appropriate places on my Jensen harddisk.
I shut down the system, and started it again with the following answer
to the aboot prompt:

0/2.2.12.gz root=/dev/sda4 

The Jensen started booting, got through a few checks with "OK", and then
finally stopped after displaying the following messages:

modprope: can't locate module lo:0
....
						[OK]
modprobe: can't locate module eth0:0
...
modprobe: can't locate module eth0:49
						[OK]
starting portmapper:

and then nothing. 
I have a feeling that I am very close, but not quite there. Anybody have
any idea here?
thanks in advance,		Jo
-- 
Joachim Schambach			Tel: (512) 471-1303
Physics Department, RLM 5.208		FAX: (798) 998-5513
University of Texas			email: jschamba@physics.utexas.edu
Austin, TX 78712, USA