taper problem

["Grant, Iain" <Iain Grant compaq com>]

Help,

Does anyone have this same issue. I have attempted to use Taper 6.9a on both
RedHat 6.0 and 6.1.
I can go into utils and create a tape.
If I go into backup, choose a directory and then finish, I always get a
segmentation fault.

My system has 3 scsi controllers. ( See end of mail for info from /proc/pci
)
The NCR810 is used because of the scsi cabling required.

I am using a TLZ09 Dat drive ( which worked fine with RedHat 5.2 .... )

Do I have to hack the code to tell it the drive is on the last scsi card (
810).

( Info from /proc/pci)

 Bus  2, device  14, function  0:
    SCSI storage controller: NCR 53c810 (rev 2).
      Medium devsel.  IRQ 20.  Master Capable.  Latency=255.
      I/O at 0x8000 [0x8001].
      Non-prefetchable 32 bit memory at 0x9800000 [0x9800000].

	( Tape and CD-Writer hanging off this card )

  Bus  3, device   0, function  0:
    SCSI storage controller: NCR 53c875 (rev 3).
      Medium devsel.  IRQ 28.  Master Capable.  Latency=255.  Min Gnt=17.Max
Lat=64.
      I/O at 0x9000 [0x9001].
      Non-prefetchable 32 bit memory at 0x9900000 [0x9900000].
      Non-prefetchable 32 bit memory at 0x9901000 [0x9901000].

	( System and user disks hanging off this card )

  Bus  3, device   1, function  0:
    SCSI storage controller: NCR 53c875 (rev 3).
      Medium devsel.  IRQ 29.  Master Capable.  Latency=255.  Min Gnt=17.Max
Lat=64.
      I/O at 0x9800 [0x9801].
      Non-prefetchable 32 bit memory at 0x9902000 [0x9902000].
      Non-prefetchable 32 bit memory at 0x9903000 [0x9903000].

	( Nothing on this card)


Thanks


Iain Grant
Software Engineer
Embedded Systems Division
SMART Modular Technologies
Ayr, Scotland

Tel:	01292 883532
Fax:	01292 883241
Email:	Iain.Grant@Compaq.com

"I think, therefore I get a headache"