[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

[dm-devel] Multipath Config Question



Hi,
    Sorry if this is the wrong place to request this.  I'm new to this and trying to setup multipathing with the following config:

SW:
 Suse SLES 9
 SP2

HW:
 3Par SAN
 2 Qlogic HBAs QLA2310s (fiber)
 drivers: qla2300/qla2xxx

I can mount the SAN device just fine:
 #mount /dev/disk/by-name/350002ac000070240 /test

I verified both HBAs work by disconnecting the fiber to each one and testing that I could mount/write/read (requires reboots).

I believe however that multipath -ll should be seeing the second HBA, correct?  Currently all I get is:
 # multipath -ll
 350002ac000070240
 [size=100 GB][features=0][hwhandler=0]
 \_round-robin 0 [active][best]
  \_ 2:0:0:0 sdg 8:96 [ready][active]

...when I expected something like:
# multipath -ll
350002ac000070240

[
size=100 GB][features="0"][hwhandler="0"]
\_ round-robin 0 [active][first]
 
\_ 1:0:1:2 sdav 66:240 [ready ][active]
  \_ 0:0:1:2 sdr 65:16 [ready ][active]
\_ round-robin 0 [enabled]
 
\_ 1:0:0:2 sdag 66:0 [ready ][active]
    \_ 0:0:0:2 sdc 8:32 [ready ][active]

Not sure what to do, like modify multipath.conf?

Suggestions/FAQs/How-Tos (I've read most of what I could Google).

Thanks,
Mike M.

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]