[dm-devel] dm-multipath with Celerra iSCSI

[Domenico Viggiani <dviggiani tiscali it>]

Hi,
I configured an iSCSI LUN on an EMC Celerra NAS. After discovered LUN by
iSCSI and ran "multipath -v2", I get:

# multipath -ls
mpath-resize-test (36006048ca49317821e436e3a5ab974f6) dm-3 EMC,Celerra iSCSI
[size=295G][features=0][hwhandler=0]
\_ round-robin 0 [prio=0][enabled]
 \_ 10:0:0:52 sda 8:0   [active][undef]
\_ round-robin 0 [prio=0][enabled]
 \_ 11:0:0:52 sdb 8:16  [active][undef]

# multipath -ll
mpath-resize-test (36006048ca49317821e436e3a5ab974f6) dm-3 EMC,Celerra iSCSI
[size=295G][features=0][hwhandler=0]
\_ round-robin 0 [prio=0][enabled]
 \_ 10:0:0:52 sda 8:0   [active][ready]
\_ round-robin 0 [prio=0][enabled]
 \_ 11:0:0:52 sdb 8:16  [active][ready]

Why is there difference between two outputs?

Then, examining "multipath -v3" output, I see "path checker = readsector0";
is it right?

In general, are multipath.conf defaults right for this Celerra filer?

Thanks in advance
--
Domenico Viggiani