[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [dm-devel] Manual failback commands



On 2/3/2010 11:55 AM, Scott Dungan wrote:
Yes, I understand that. If I run 'multipathd -k' and then help, these are the commands that are listed:

     list|show paths
     list|show maps
     add path $path
     remove|del path $path
     add map $map
     remove|del map $map
     switch|switchgroup map $map group $group
     dump pathvec
     reconfigure
     disablequeueing map $map
     restorequeueing map $map


Where are the 'reinstate path' or 'fail path' directives you mention in this thread? In case this is a version issue, we are running with version device-mapper-multipath-0.4.7-30.el5_4.4. What version are you running where the 'reinstate path' or 'fail path' directives are listed in help or otherwise function?

-Scott

--
dm-devel mailing list
dm-devel redhat com
https://www.redhat.com/mailman/listinfo/dm-devel

It looks like I have answered my own question. I was confused about which version we were running. I was testing against version 4.5. Those commands are not available in version 4.5 (RHEL 4.8). They are present in version 4.7 (RHEL 5.x).

Thanks for your help.

-Scott

--

Scott A Dungan
Systems Administrator
GPS Division
California Institute of Technology
Phone: (626) 395-3170
Fax:   (626) 585-1917


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]