Panel Segmentation Fault

[Steven Bradley <steven sgb dyndns org>]

I am hoping someone can help me with this problem.

I have installed at least three times, RH 7.2 and each time when I go to
start X (startx), it comes back with a Fatal Error while loading the panel
at the bottom of the screen.  It is due to a segmentation fault.  It will
happen every time I install and try to start X.  It will also do it every
time I try to start X and not just after an install as well.

Bottom line -- I can not get X to run on RH 7.2 without the Panel crashing
every time.  I use KNOME obviously.

I tried RH 7.1 and it does not have this problem.  It works perfectly.

But there are some nice features in 7.2 and I am creating a new server
(EISA, SCSI, AMI BIOS/Motherboard) and would like the latest on it.

I have searched all over the net and found a few references to other people
with this problem, but no solutions.  I have checked on redhat.com and it
appears to them the problem is non-existant by the lack of any reference to
it at all.

I can make it fail so well, if someone does have a fix, it will be easy to
test it out.

If anyone can help, I will appreciate it.  If not, I will have to make a
decision at some point to use 7.1 as it does at least function without
crashing every time.  Hopefully someone may know the answer to this, or
perhaps it will be "wait for 7.3".

Steven
-- 
Steven Bradley            121 Cambridge Drive, Longwood, FL  32779-5707  USA
steven sgb dyndns org                 Home: (407) 862-7226 or (407) 869-4598