Re: Panel Segmentation Fault

[Aaron Konstam <akonstam trinity edu>]

On Sun, Dec 30, 2001 at 09:44:30PM -0500, Steven Bradley wrote:
> Well this produced more problems:
> 
> Kernel panic: No init found.  Try passing init= option to kernel.
> 
> and it hangs.  With old kernel, still boots/runs correctly.  This is with
> a fresh install.  The initrd image appears to be ok.  It could be the fact
> I am using both the 2840VLB and 2940W controllers (narrow VLB EISA SCSI
> and wide EISA SCSI) and perhaps the SCSI driver needs an update.  I loaded
> the SCSI driver and SMC EISA Ultra drivers individually during the install.
> 
> If I need new driver(s) for SCSI and or the two SMC cards, where would I
> find compatible drivers to go with this kernel?
> 
> Any clues?  I appreciate your help.  Steven
> 
> Previously, on Sun Dec 30 13:58:43 2001, rkelsoe ev1 net said:
> 
You need 2 initrd files ; one for each kernel. This error indicates
that:
1. you don't have a proper initrd file for this kernel.
or 2. After the file for the new kernel was created lilo was not run. It
must be run everytime a new boot realted file is created.
-- 
-------------------------------------------
Aaron Konstam
Computer Science
Trinity University
715 Stadium Dr.
San Antonio, TX 78212-7200

telephone: (210)-999-7484
email:akonstam trinity edu