[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: Kudzu issue



Alan,

The chip we're looking at is a RealTek 8139... 
here is the lspci -vxx output you asked for on bootup (hacked
the init script so it ran just before kudzu started). 

00:0d.0 Ethernet controller: Realtek Semiconductor Co., Ltd. 
RTL-8139/8139C/8139C+ (rev 10)
        Subsystem: Realtek Semiconductor Co., Ltd. RT8139
        Flags: bus master, medium devsel, latency 32, IRQ 11
        I/O ports at b800 [size=256]
        Memory at ee800000 (32-bit, non-prefetchable) [size=256]
        Capabilities: [50] Power Management version 2
00: ec 10 39 81 07 00 90 02 10 00 00 02 00 20 00 00
10: 01 b8 00 00 00 00 80 ee 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 ec 10 39 81
30: 00 00 00 00 50 00 00 00 00 00 00 00 0b 01 20 40


Peter.


On Monday 17 May 2004 13:52, Alan Cox wrote:
> On Fri, May 14, 2004 at 06:21:39PM -0400, Peter Arremann wrote:
> > the drivers by hand and then run kudzu. it will try to reconfigure the
> > device. Ignore that. Then use ifconfig to up the device (no IP required)
> > and then rerun kudzu.. it should work this time - at least on the 2 cards
> > I've tried that fixed the problem.
>
> Gak.. does lspci -vxx show the cards are in D3 (sleeping) state at this
> point (post the dump for the chip please). Could be there are cases
> where we need power management to turn on the chip before using it



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]