Re: Cannot print to file in Fedora

["Jóhann B. Guðmundsson" <johannbg hi is>]

Manuel Wolfshant wrote:
> Jóhann B. Guðmundsson wrote:
> > Matej Cepl wrote:
> > > On 2008-03-11, 10:38 GMT, Jóhann B. Guðmundsson wrote:
> > >  
> > > > You do so by open a termina and run
> > > > echo 0 > /selinux/enforce
> > > >     
> > >
> > > You do so by opening a terminal and run (as root, of course):
> > >
> > > setenforce 0
> > >
> > > Matěj
> > >
> > >   
> > What both Matej and Tim forget to mention is
> > the fact that by running setenforce 0 command
> > it will change your selinux configuration settings permanently to 
> > permissive
> > hence on next reboot your selinux would be running in permissive mode
> > instead of enforcing mode and leave your computer less secure...
> Since when is this valid? On my system permanent changes must be done 
> via /etc/sysconfig/selinux. setenforce looses its effects after reboot
Since I apperantly was born stuborn and have to have the last word in 
hasting misread the man page
( since I was being criticized by Matej by suggesting to the user the 
selinux might be the culprit and showing him
how to set selinux to permissive mode with echo which apparently is not 
as as fansy way to do it as setenforce.. ) note Tim showed
him the other way (  the apparently popular way ..setenforce 0 ) 8 
minutes after I responded to him  to achieve the same thing.. 

Don't worry I wont bother helping users again that accidental post to 
this list...

Best regards.
                  Johann B.


begin:vcard
fn:Johann B.  Gudmundsson
n:Gudmundsson;Johann B. 
org:Reiknistofnun - University of Iceland;IT Management
adr:Dunhagi 5;;Taeknigardur;Reykavik;;107;Iceland
email;internet:johannbg hi is
title:Unix System Engineer RHCE,CCSA
tel;work:+3545254267
tel;fax:+3545528801
tel;pager:N/A
tel;home:N/A
tel;cell:N/A
url:http://www.rhi.hi.is
version:2.1
end:vcard