Network configuration problems
Thomas E. Dukes
edukes at alltel.net
Fri Aug 20 02:53:58 UTC 2004
On Thu, 2004-08-19 at 22:16, Kellie Blackwell wrote:
> Ever since I upgraded my RH7.3 box to Fedora Core 2, I have not been
> able to use my network card. It seems something in my setup thinks I
> want IPv6 instead of IPv4. During the boot process, I get a message
> saying that eth0 is started but when I do an 'ifconfig -a ', all I
> have is a sit0 device.
>
> While looking at /var/log/messages I see an entry that says:
>
> "IPv6 over IPv4 tunneling driver"
>
> Does this mean that someting in the kernel is set to use only IPv6?
>
> If I boot from the CD in rescue mode and answer Yes when asked if I
> want to start the network, eth0 is configured but when I boot normally
> I always get sit0. I have tried setting NETWORKING_IPV6=NO in
> /etc/sysconfig/network and even tried renaming all the IPV6 related
> files in /etc/sysconfig/network-scripts to no avail.
I don't know what brand nic you have but I ran into similar problems
with a 3Com 3C509B (think thats the model). I finally had to scrap it
and get something different. I think some of the older cards are no
longer supported. This may be whats happening with your card.
--
Thomas E. Dukes <edukes at alltel.net>
More information about the fedora-list
mailing list