FC2 is not detecting my hard drive on a 29160 SCSI adapter during
install. Can anyone help?
I'm trying to install FC2 on a machine with only 1 hard drive that is
attached to an Adaptec 29160 SCSI controller. The AIC-7xxx driver is
automatically loading and is finding my adapter (I can see this by
hitting <F4> while module is loading. However, my disk drive is not
found. When I get to automatically partitioning, I get "no drives
found". I had no problems installing and running Redhat 9.0
previously
on this machine. I also tried FC3-test1 but it didn't help.
When I hit <F4> while AIC-7XXX module is loading on FC2, I get the
following:
<6>PCI: Found IRQ 5 for device 0000:00:0d.0
<6>scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
<4> <Adaptec 29160 Ultra160 SCSI adapter>
<4> aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
<4>
<4>(scsi0:A:0): 160.000MB/s transfers (80.000MHz DT, offset 63, 16
bit)
<4>scsi0: Unexpected busfree while idle
<4>SEQADDR == 0x1