Linksys WPC54Gv2 + acx111 + FC4

[Efthym]

For future reference ... It works now !!

http://195.66.192.167/linux/acx_patches/acx_fw/acx111_xterasys_xn2522g/fw3/

used the xterasys_xn2522g drivers,
76268 d5147672b1e00ba61d0eff24c064bfe9 Fw1130.bin_1.2.0.30
  7208 ae57fc2f9fb79d421314c8ba95af0123 RADIO16.BIN

just copy Fw1130.bin to /usr/share/acx/TIACX111.BIN
and RADIO16.BIN to /usr/share/acx/RADIO16.BIN

#modprobe acx_pci




On Sun, 21 Aug 2005 00:31:25 +0300, Efthym <efthym at gmx.net> wrote:

> Hi all,
>
> I've been trying to setup up this card using the native linux driver with
> no luck. I followed the directions at
> http://www.houseofcraig.net/acx100_howto.php
> since "lspci -n" says the chipset is 104c:9066. I downloaded
> acx100-0.2.0pre8_plus_fixes_57.tar.gz and copied RADIO16.BIN from the
> vendor cd to /usr/share/acx. The module compiled and loaded perfectly,  
> but
> "iwlist wlan0 scan" does not return any results and DHCP does not receive
> an IP. I'm not using WEP or any encryption.
>
> Here are some outputs I get.
>
>
> [root at purgatory WPC54Gv2_40826]# ifconfig wlan0
> wlan0     Link encap:Ethernet  HWaddr 00:13:10:16:95:7D
>             UP BROADCAST MULTICAST  MTU:1500  Metric:1
>             RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>             TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>             collisions:0 txqueuelen:1000
>             RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>             Interrupt:11
>
> [root at purgatory WPC54Gv2_40826]# iwconfig
> lo        no wireless extensions.
>
> eth0      no wireless extensions.
>
> wlan0     IEEE 802.11b+/g+  ESSID:"CHRAV"
> Nickname:"purgatory.bakouria.org"
>             Mode:Managed  Frequency:2.412 GHz  Access Point:
> 00:00:00:00:00:00
>             Bit Rate:54 Mb/s   Tx-Power=15 dBm   Sensitivity=1/3
>             Retry min limit:7   RTS thr:off
>             Encryption key:off
>             Power Management:off
>             Link Quality:0  Signal level:0  Noise level:0
>             Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>             Tx excessive retries:0  Invalid misc:0   Missed beacon:0
>
> [root at purgatory WPC54Gv2_40826]# iwlist wlan0 scan
> wlan0     No scan results
>
>
> Any help appreciated .
>