Re: link status for 3Com ethernet in fc4?

[Bob Chiodini <rchiodin bellsouth net>]

On Fri, 2005-09-30 at 13:18 -0400, sean wrote:
> Where do I find the link status - 10mps, 100mps, 
> half-duplex, duplex, etc -  for a 3Com ethernet adapter in fc4.
> 
> I have two adapters on this machine, eth1 is the 3Com. dmesg 
> shows:
> 
> .......................
> 8139too Fast Ethernet driver 0.9.27
> eth0: RealTek RTL8139 at 0xfc00, 00:48:54:8b:ab:29, IRQ 11
> eth0:  Identified 8139 chip type 'RTL-8139B'
> 3c59x: Donald Becker and others. 
> www.scyld.com/network/vortex.html
> 0000:00:0f.0: 3Com PCI 3c595 Vortex 100baseTx at 0xff80. 
> Vers LK1.1.19
> 0000:00:0f.0: Overriding PCI latency timer (CFLT) setting of 
> 64, new value is 248.
> ..............
> eth0: link up, 10Mbps, half-duplex, lpa 0x0000
> ..................
> eth1: no IPv6 routers present
> eth0: no IPv6 routers present
> ......
> 
> 
> ifconfig doesn't help.
> 
> ???
> 
> sean
> 

Sean,

Does mii-tool or ethtool work for this device?

Bob...