USB Ethernet adapters D-Link DUB-E100

[Dario Lesca]

Hi, I must configure a External USB Ethernet adapters D-Link DUB-E100,
this is the my /proc/bus/usb/drivers info:

T:  Bus=01 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#=  4 Spd=480 MxCh= 0
D:  Ver= 2.00 Cls=ff(vend.) Sub=ff Prot=00 MxPS=64 #Cfgs=  1
P:  Vendor=07d1 ProdID=3c05 Rev= 0.01
S:  Manufacturer=D-Link Corporation
S:  Product=DUB-E100
S:  SerialNumber=000001
C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=250mA
I:  If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=ff Prot=00 Driver=(none)
E:  Ad=81(I) Atr=03(Int.) MxPS=   8 Ivl=128ms
E:  Ad=82(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=03(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms

when I plug the adapters into USB port I get this dmesg info:

usb 1-2: new high speed USB device using ehci_hcd and address 5
usb 1-2: configuration #1 chosen from 1 choice

... but none happening.

I have found this web page
http://www.linux-usb.org/usbnet/
which say then this device is support from asix driver (and usbnet).

But if I modprobe this drivers none happening ...
the "ip addr" command not show a new net network device.

It is possible to use this device?
How I can configure this device?

Many thanks to all!

-- 
Dario Lesca <d.lesca at solinos.it>