USB Ethernet adapters D-Link DUB-E100
Mikkel L. Ellertson
mikkel at infinity-ltd.com
Wed Jun 14 14:25:20 UTC 2006
Dario Lesca wrote:
> Hi, I must configure a External USB Ethernet adapters D-Link DUB-E100,
> this is the my /proc/bus/usb/drivers info:
>
> T: Bus=01 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#= 4 Spd=480 MxCh= 0
> D: Ver= 2.00 Cls=ff(vend.) Sub=ff Prot=00 MxPS=64 #Cfgs= 1
> P: Vendor=07d1 ProdID=3c05 Rev= 0.01
> S: Manufacturer=D-Link Corporation
> S: Product=DUB-E100
> S: SerialNumber=000001
> C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=250mA
> I: If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=ff Prot=00 Driver=(none)
> E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=128ms
> E: Ad=82(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
> E: Ad=03(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
>
> when I plug the adapters into USB port I get this dmesg info:
>
> usb 1-2: new high speed USB device using ehci_hcd and address 5
> usb 1-2: configuration #1 chosen from 1 choice
>
> ... but none happening.
>
> I have found this web page
> http://www.linux-usb.org/usbnet/
> which say then this device is support from asix driver (and usbnet).
>
> But if I modprobe this drivers none happening ...
> the "ip addr" command not show a new net network device.
>
> It is possible to use this device?
> How I can configure this device?
>
> Many thanks to all!
>
What does "ifconfig -a" show?
Mikkel
--
Do not meddle in the affairs of dragons,
for thou art crunchy and taste good with Ketchup!
More information about the fedora-list
mailing list