tx_flow_control_pause NIC => WRT54G

[Jorge Luis Gonzalez <lists jorge cc>]

My NIC (Intel 100VE) is set to 100baseT/Full (autoneg off) running
into a Linksys WRT54G with the latest stock firmware.  I'm getting
some high numbers in tx_flow_control_pause.  Ideally, ethtool should
return a 0 for that line, I believe.  Does anyone have any clues as to
why this might be happening?  Outbound hops in traceroute don't show
any undue latency in the first hop, but the (outside) network is a bit
bursty.  ifconfig shows no errors.  The box is running FC6, stock
kernel.

On a related note, in Linux, should the MTU on the NIC be set to match
the MTU of the router (1492), or should I leave it at 1500?

Thanks for any help,

       Jorge Luis

[root satyr ~]# ethtool -S eth0
NIC statistics:
     rx_packets: 1067
     tx_packets: 1241
     rx_bytes: 311358
     tx_bytes: 112179
     rx_errors: 0
     tx_errors: 0
     rx_dropped: 0
     tx_dropped: 0
     multicast: 0
     collisions: 0
     rx_length_errors: 0
     rx_over_errors: 0
     rx_crc_errors: 0
     rx_frame_errors: 0
     rx_fifo_errors: 0
     rx_missed_errors: 0
     tx_aborted_errors: 0
     tx_carrier_errors: 0
     tx_fifo_errors: 0
     tx_heartbeat_errors: 0
     tx_window_errors: 0
     tx_deferred: 0
     tx_single_collisions: 0
     tx_multi_collisions: 0
     tx_flow_control_pause: 64560
     rx_flow_control_pause: 0
     rx_flow_control_unsupported: 0
     tx_tco_packets: 0
     rx_tco_packets: 0
[root satyr ~]# 

[root satyr ~]# ifconfig eth0
eth0      Link encap:Ethernet  HWaddr XXXXXXXXXXXXXXX
          inet addr:192.168.1.5  Bcast:192.168.1.255
          Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:2094 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2932 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:426358 (416.3 KiB)  TX bytes:254330 (248.3 KiB)

-- 
Jorge Luis González <lists jorge cc>
GPG KEY -> 0x65751721