Where is eth0/eth1/assigned -
Bob Goodwin
bobgoodwin at wildblue.net
Thu Jun 4 19:16:31 UTC 2009
I am still struggling with this f10 install. It appeared that the
NIC in eth0 was no good. I pulled it out and left the second card
which was/is eth1.
It looks to me like that designation eth1 might be changed to eth0
using ethtool but if so, I can't find the right command.
I have used service-config-network to set it up as 192.168.1.10 and
eth1, network-scripts is set up for eth1. but no matter what I do a
ping to another computer yields "Network is unreachable."
This is a wired connection. I've tried a different cat5 cable.
"ethtools eth1" looks ok compared to the other computers. Not sure
what I have missed but it would be simpler perhaps if I could
convince the NIC that it was eth0 instead of eth1 but I can't
determine how that is set.
Any help appreciated. I am about at wits end.
Bob
More information about the fedora-list
mailing list