[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

test3 vs make xconfig



Greets all;

I just ran a make xconfig on that fresh install of test3 on my shop 
box as I wanted to turn on a full fledged ISA bus scan since there 
are two custom made 8 bit ISA cards containing a few relays and 
apparently a whole 8 bit wide input port per card, and while I have 
what appears to be normal fonts elsewhere, all I get on the xconfig 
screen are gfx chars, little boxes of various shapes and half, 
quarter, and full moons in a character sized box.

That box isn't on a network allthough it may be eventually when I can 
figure out howto get some cat5 run to the shop building.  I hate 
digging ditches, been there, done that once already for power out 
there.

Running gnome of course since there is apparently no terminals 
available if I switchdesk to kde.  And it sure don't look like the 
kde I'm looking at here!

How can I fix these fubared characters?

-- 
Cheers, Gene
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
99.22% setiathome rank, not too shabby for a WV hillbilly
Yahoo.com attorneys please note, additions to this message
by Gene Heskett are:
Copyright 2004 by Maurice Eugene Heskett, all rights reserved.



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]