[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: FC2T3 X Configuration - No devices detected



On Fri, 2004-05-14 at 09:52, Götz Reinicke wrote:
> Hi,
> 
> I recently installed FC2T3 on an older PII 366 for a test. The 
> Installation from an NFS Server hosting the isos worke fine.
> 
> But after the reboot, there is no loginscreen, the disply stays black.
> In the Xorg.0.log there is on EE : (EE) No devices detected.
> 
> This is confusing me, because the messages of the boot process are shown 
> and I could use the gfx installation mode which is asking for the 
> display configuration and settings.
> 
> I can remember that there has been a problem like that on my toshiba 
> labtop and I had to edit the xorg.conf by hand (Hsync... something)

If the Monitor does not support DDC then the HSYNC ranges are #'ed out,
an update version of the libraries that have fixed the problem will be
available in FC2.

Here's the bug relating to it
https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=120950

However this just forces the resolution to 640*480, so I'm not sure this
is the problem your having.

> The graphiccard is an elsa winner1000/T3D AGP, the monitor an iiyama 
> visionmaster 403 17".

The only thing I can suggest, is trying to update your system (yum -y
update) at the command line, make sure you have all latest stuff, and
then try system-config-display --reconfigure to try and set it up again.

That may help, but not sure.

Doug



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]