Re: [K12OSN] Finding MAC address for NIC

[Doug Simpson <simpsond leopards k12 ar us>]

It shows up in dmesg, but that is it.

This was in there from a new install and it used to be active, but somehow 
it got crossways with one of the other NICs and I had to unconfigure it.  
It hasn't been visible since. . .

Will try to remove it and reboot and reset it up and see what happens. . .

Doug Simpson
Technology Specialist
DeQueen Public Schools
DeQueen, AR 71832
simpsond leopards k12 ar us
Tux for President!

On Thu, 27 Apr 2006, Les Mikesell wrote:

> On Thu, 2006-04-27 at 09:17, Doug Simpson wrote:
> > I need the MAC address *so that I **can** use the GUI config tool* to 
> > configure it.  That GUI keeps wanting to assign it to one of the other two 
> > and then stuff stops working.
> > 
> > In other words, the GUI thing only shows and lets me configure the 
> > hardware that are currently on eth0 and eth2 MAC addresses.  That third 
> > one does not show up as configurable.  If I set it up, it actually sets 
> > both interfaces on the same NIC and there goes the rest of the network.  
> > This is why I need the MAC address so I can force it to use that third 
> > NIC.
> > 
> > Hope this is understandable. . .
> 
> If 'dmesg' shows that eth1 was detected at boot time you should
> have an eth1 in the GUI that you can edit, and the hardware
> tab should show the NIC brand.  Did you add this interface
> after installation or move/clone the system drive from a
> different machine?  
> 
> -- 
>   Les Mikesell
>    les futuresource com
> 
> 
> _______________________________________________
> K12OSN mailing list
> K12OSN redhat com
> https://www.redhat.com/mailman/listinfo/k12osn
> For more info see <http://www.k12os.org>
>