RE: Ethernet bonding configuration

["Shabazian, Chip" <Chip Shabazian bankofamerica com>]

We do this in our %post.  Basically, we Kickstart and build from eth0,
then source the ifcfg-eth0 file and use that to setup the bond0, then
overwrite the eth0 and eth1 config files.

-----Original Message-----
From: kickstart-list-bounces redhat com
[mailto:kickstart-list-bounces redhat com] On Behalf Of Murali Potla
(mpotla)
Sent: Tuesday, September 30, 2008 11:31 AM
To: Discussion list about Kickstart
Subject: Ethernet bonding configuration


Is it possible to configure the network devices as bonded devices via
kickstart process. 
 
Bond0 with a specific IP address and eth0 and eth1 as the slaves ? 

Thanks,
Murali 

_______________________________________________
Kickstart-list mailing list
Kickstart-list redhat com
https://www.redhat.com/mailman/listinfo/kickstart-list