[linux-lvm] problem with 2.6.15-rc5
Sebastian Kuzminsky
seb at highlab.com
Wed Dec 21 21:23:49 UTC 2005
Old Fart <rascal.jumper-747 at cox.net> wrote:
> Sebastian Kuzminsky wrote:
> > I'm seeing almost immediate, perfectly repeatable hard lockups in
> > 2.6.15-rc5 and 2.6.15-rc5-mm3, when using sata_mv, RAID, and LVM together.
> >
> FWIW, I have a setup similar to yours with Intel ich5 and sata promise,
> software raid5 PVs and root partitions on LVs. During the install of
> etch I had to go to terminal 2 during the partitioning process to get
> the raid devices started and then do lvm vgscan, etc, so the partitioner
> properly saw the LVs. Even so, a recent netinst of etch failed using
> this method and borked one of my arrays. An earlier etch CD install
> worked ok with the fiddling done in TTY2. I have seen the same
> characteristics when installing other distros (Fedora 5, XOSLinuxPC
> (really hard to do), Ubuntu, Gentoo, Fedora 4, Mandriva) not starting
> the raid sets and then not being able to initialize the LVs and have had
> to use the TTY2 approach. A notable exception was SuSE which did it
> right from the start. Gentoo is really hard to do, I had to hack the
> initrd to get the raid nodes made and run vgscan, vgchange, etc. Good
> luck!!
It's not an install problem. The system's up and running, I just added
some more hardware. I can make the RAIDs fine and the LVM components
fine, but when I use them together the system hangs.
--
Sebastian Kuzminsky
More information about the linux-lvm
mailing list