[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [linux-lvm] Removing a very old physical drive



Nicholas Robinson [npr bottlehall co uk] wrote:
> Hi
> 
> I've been using lvm for quite a few years, but only occasionally when I
> need to add/remove new drives. So, my knowledge is limited and a bit
> rusty! I should have removed the old drive when I added a new one a
> couple of years ago, but for reasons I cannot remember, I didn't.
> 
> I only know how to remove a drive when there is a new drive about to
> move the stuff onto. My problem now is that the new drive is fully
> allocated and so this route won't work. There is plenty of free space on
> the new drive so it should be possible to move everything that might be
> on the old physical drive and then remove it from the lvg. I just can't
> work out how. The HOWTOs and threads don't seem to cover this starting
> point.
> 
> My questions are:
> 
> 1. Can I do move the data off the old drive to the new drive without
> adding another new drive?
 
pvmove followed by vgreduce. If you have enough free space, pvmove
should work and there is no need to add another new drive.

> 2. I don't understand the output from pvdisplay - why is it telling me
> about /dev/sda1 at the bottom when this partition is a boot partition
> and tiny?

It also reports a large size! Somehow, it detected PV signature in that
partition. You can remove such signature by running pvremove. Note that
it wipes out LVM label, so back up your data in /dev/sda1 somewhere else
before you run "pvremove /dev/sda1". If the partition is mountable after
'pvremove', you are fine. Otherwise restore the backup!

> 3. Where has the LogVol01 come from and what is it doing? Can I remove
> it?

Try mounting it and see if there is anything there. You can use lvremove
if you don't need it.

> 4. Can I rename the volgroup/logvols to the same pattern used by new
> installations? e.g. vg_hostname and lv_root, etc.

Yes, see lvrename and vgrename commands.
 
> If you've read this far, then thank you! I hope the following extracts
> are sufficient.

You are welcome.


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]