Re: [linux-lvm] LVM over iSCSI

[Ray Morris <support bettercgi com>]

What says lvscan -vv ?
--
Ray Morris
support bettercgi com

Strongbox - The next generation in site security:
http://www.bettercgi.com/strongbox/

Throttlebox - Intelligent Bandwidth Control
http://www.bettercgi.com/throttlebox/

Strongbox / Throttlebox affiliate program:
http://www.bettercgi.com/affiliates/user/register.php


On 01/05/2011 11:48:54 AM, Roberto Sassu wrote:
> Hi all
>
> i configured a LVM volume group using two iSCSI devices as
> physical volumes.
> I designed one node (A) to create snapshots of a Logical Volume,
> called 'lv_origin' and i want other nodes (B, C) access them
> exclusively.
> I assume that 'lv_origin' is never modified after the first snapshot
> is created.
> So, A first creates 'lv_origin' and then a snapshot called
> 'lv_snap1', which is available for this node.
> The node B executes the command 'vgscan' and 'vgchange -ay'.
> In this way, 'lv_origin' and 'lv_snap1' become available for B.
> Next step, A creates a new snapshot of 'lv_origin' called
> 'lv_snap2'. This is not available for B and the only way that i
> found to use it is to perform (on the node B) the following
> commands:
>
> 1) vgscan
> 2) vgchange -an
> 3) vgchange -ay
>
> However this procedure is not applicable if one of created
> LVs is in use. How to solve this issue?
>
> Thanks in advance for replies
>
> Roberto Sassu
>
> _______________________________________________
> linux-lvm mailing list
> linux-lvm redhat com
> https://www.redhat.com/mailman/listinfo/linux-lvm
> read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/