On Mon, 2005-07-11 at 17:29 -0400, Radu Brumariu wrote:
Hi,
I have a machine with 2 RAID controllers ( 1 ICH5R - onboard, and add-on
card Adaptec 1210SA) .I also have 2 drives that I want to build a RAID 0
with.
I tried this on both controllers :
1. connect the drives to controller
2. configure the controller in RAID 0
3. boot off CD and start the RHEL4 installation
At this point , when it comes down to partition drives, it complains
that the drives have no partition information and asks to initialize
them . Basically it doesn't see 1 drive ( the logical RAID 0 ) , but 2.
I know that both controllers are software raid, but how can I make this
work ? Any pointers, suggestions are appreciated :)
you either need to use software raid, or, post install, the dmraid
program.
--
nahant-list mailing list
nahant-list redhat com
http://www.redhat.com/mailman/listinfo/nahant-list