Re: RHL + Compaq Presario

[John Arnold <jaarnol ibm net>]

At 01:40 PM 10/1/97 -0800, you wrote:
>In a flurry of excitement over getting our RH Linux firewall up and 
>running (relatively) painlessly on a PPro 200 system, we then dashed out 
>and grabbed the first bargain-basement system we could find to make the 
>final system. We bought a (*grimace*) Compaq Presario 4716.
....etc

You need Compaq Softpaq solution SP1116 (or later if superceded). This
contains the MOVEPCI utility. The procedure is:

1) Set up small DOS partition
2) Boot from DOS, including MOVEPCI.SYS in the config.sys and LOADLIN in
autoexec.bat


That's it. Works fine from there on in

Regards