RV: svgalib & ATI rage pro chipset

["Fjoe" <fmc redestb es>]

Hello friend.

Donwload the following packages from ftp.redhat.com contrib
(contrib/hurricane/i386)

XFree86-100dp1-fonts-3.3.2
XFree86-3.3.2
XFree86-75dpi-fonts-3.3.2
XFree86-Mach64-3.3.2
XFree86-VGA16-3.3.2
XFree86XF86Setup-3.3.2
XFree86-libs-3.3.2
XFree86-xwrapper-3.3.2

Just get those rpms, put them to the same directory an do "rpm -Uvh
XFree86*". VGA16 is needed by XFree86-XF86Setup.
If you have some problem during the installation  looks at the pages 123 at
125 of the manual of RedHat 5.0 book where it describes you the solution for
all type of errors.
Once installed all these  packages must execute Xconfigurator or XF86Setup
or xf86config and you found the graphic card ATI 3D RAGE PRO.
Some time ago I installed it and work fine

I hope this can help you.

>-----Mensaje original-----
>De: Andrew Taylor <andy hot-shot com>
>Para: redhat-install-list redhat com <redhat-install-list redhat com>
>Fecha: viernes 3 de abril de 1998 18:41
>Asunto: svgalib & ATI rage pro chipset
>
>
>>Hi.
>>
>>After getting through the technical side of linux, I've started on the fun
>>side. I downloaded 9mb of Quake II and managed to set it up to read the
>data
>>files through a sym link to a fat partition etc. However I'm only able to
>>get it running at 300 x 240 which is the base resolution. I think I need a
>>copy of svgalib. I downloaded one copy but it doesn't seem to support my
>>card (ATI expert work). My card runs fine under  MetroX but not under
>>quakeII, any ideas ?
>>
>>Andy
>>
>>
>>
>>--
>>  PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
>>http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips
/mailing-lists
>>         To unsubscribe: mail redhat-install-list-request redhat com
>>                     with "unsubscribe" as the Subject.
>>
>> Problems should be addressed to <listmaster redhat com>.
>>
>