[Date Prev][Date Next] [Thread Prev][Thread Next]
[Thread Index]
[Date Index]
[Author Index]
Re: again: about monitor and network card!
- From: Mike Adams <trent crystalwind com>
- To: redhat-install-list redhat com
- Subject: Re: again: about monitor and network card!
- Date: Sun, 29 Aug 1999 16:32:09 -0400
Hi,
I'm using a Linksys, too. You need to be a little more spcific on which
model you're using.
If you have a dual-boot win9x system, check the system properties->device
manager->system resources for the information.
If you have a reasonably new model (Ether16 model# lne2000) you'll need to
make a bootable DOS floppy and run the setup program from a _DOS_ session
(you can't run this inside windows!) to make your settings.
If you have an older board with jumper settings, you'll need to open the
box and check the board hoping that there's a screening with the settings
info.
Shoot me an email if you need some more help.
Troubleshooting and Setup Program:
http://www.linksys.com/support/solution/set2000p.htm
General Linux Help:
http://www.linksys.com/support/solution/nos/linux_others.htm
________________________________________
(this is the lne2000 blurb from the Linux page)
Ether16 LAN Card
If you have the plug-and-play version of the Ether16
(released in mid-1997), install the card in a DOS
workstation and run its Setup program to take the card out
of plug-and-play mode before beginning the Linux
installation--the card won't work properly with Linux while
in plug-and-play mode.
This card will work with the ne driver (ne2000) in most
distributions using Kernel 2.x
____________________________________
Cheers,
Trent The Thief
At 12:49 PM 8/29/99 -0400, you wrote:
>I have a Lynk Systems ne2000 compatable network card, I am having the same
>problem, I guess we have to find out the exact io address and IRQ for the
>card, I have no idea how to find this info out, ANY IDEAS???/?
>
>Kyle Blake
>
++++++++++++++++++++++++++++++++++++++++++++++++++++
Mike Adams ring crystalwind com
Crystal Wind Consulting www.crystalwind.com
Technical Writing / Data Programming
+++++++++++++ MY Lock, MY Key ++++++++++++++++++++++
PGP 2048-bit 0xED978AB5
+++++++++++++++++++++++++++++++++++++++OSOK!$-7-6-3+
[Date Prev][Date Next] [Thread Prev][Thread Next]
[Thread Index]
[Date Index]
[Author Index]