Re: iomega ZIP250 parallel Port Drive

[Baoqing Ye <baoqing Basit COM>]

  No.  You meant I need to rebuild the kernel before make the module?


Eric Larson wrote:

> Did you run configure before make?
>
> On Fri, Dec 17, 1999 at 01:13:22PM -0500, Baoqing Ye wrote:
> >
> >  I am trying install the  iomega ZIP 250 Parallel Port Drive onto RH6.1
> >
> >  When I tried to make the module (imm.o) I got error message during the "make" -
> >  "Makefile:15:  /usr/src/linux/.config: No such file or direcrtory
> >    Makefile:39: ***missing separator. Stop"
> >
> >   Does anyone know what the "/usr/src/linux/.config" is supposed to be? HOWTO says
> > this driver works fine for ZIP250 PPD under linux (not mentioned anything about
> > "make").
> >   Am I missing something here?
> >
> >
> > Thank in advance.
> >
> > -Baoqing
> >
> >
> > --
> >   PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
> >               http://www.redhat.com http://archive.redhat.com
> >          To unsubscribe: mail redhat-install-list-request redhat com with
> >                        "unsubscribe" as the Subject.
> >
> >
>
> --
>   PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
>                 http://www.redhat.com http://archive.redhat.com
>          To unsubscribe: mail redhat-install-list-request redhat com with
>                        "unsubscribe" as the Subject.