Re: Network card installation

[Tom Cooper <tom_cooper bigfoot com>]

This depends whether you've got networking support in the kernel or in a
module.
Take a look at the conf.modules and see if the module is listed there.
Use the lsmod command to see what modules are actually loaded.
Try loading the module manually to see if it will work manually (insmod)

This may get you started....

Regards,
Tom
>
>
>-----Original Message-----
>From: Jim Reynolds [mailto:reynolds exotrope net]
>Sent: Friday, May 28, 1999 4:07 PM
>To: redhat-install-list redhat com
>Subject: Re: Network card installation
>
>
>David,
>
>This is a dual boot machine, linux/win95.  The network card is working
>ok on the win95 side.  On the linux side, I can't ping or telnet to or
>from. On bootup I get the "delaying eth0 initialization" message. 
>Ifconfig shows no Rx/Tx packets being transmitted.  I wonder if the
>tulip driver is being loaded.  Where do I check on that?
>
>
>
This message reflects the personal views and opinions of the author only,
and not necessarily those of any organizaion to which the author is
related.