Re: eth1 - inactive

["A. Benjamin" <postbox new-wen net>]

Thanks, I'll give it a try.
----- Original Message -----
From: Rizwan Mohammad <rizwan clovertechnologies com>
To: <redhat-install-list redhat com>
Sent: Tuesday, June 20, 2000 6:20 PM
Subject: Re: eth1 - inactive


>
> At the lilo prompt  LILO : linux ether=<your_irq>,<your_ioaddr>,eth1.
> (eg. linux ether=5,0x300,eth1). If this works and u want to stick to it
then
> simply add the line in your lilo.conf as -
append="ether=<irq>,<ioaddr>,eth1"
> (The " " are needed). and then run the lilo command to activate the
changes.
> This way u avoid typing the ether command at every LILO prompt.
>
> Rizwan
>
> On Sun, 18 Jun 2000, A. Benjamin wrote:
> >
> > Hello forum,
> >
> > I need help putting in two Ethernet cards. The first one I installed has
no problem. It works fine. It was also installed before I loaded Linux 5.2
Apollo version. When I installed the second, it does not register as being
ACTIVE.
> >
> > I use the commands: ifconfig and dmesg to see if the second shows up; it
doesn't.
> > I also went into the network configuration under the GUI, added it
manually, but still to no avail.
> >
> > Can anyone hint to some suggestions?
> > Thanks, Alvin.
> >
> >
>
> ----------------------------------------
> Content-Type: text/html; name="unnamed"
> Content-Transfer-Encoding: quoted-printable
> Content-Description:
> ----------------------------------------
>
>
> --
> To unsubscribe: mail redhat-install-list-request redhat com with
> "unsubscribe" as the Subject.
>
>