RE: Lost eth0 on Redhat 6.1

["Garcia, Kanchana" <Kanchana Garcia sycamorenet com>]

1.	Tried new network card.  Then tried transplanting the Hard Drive to
a new machine on a different switch.  Same problem.

2.	ONBOOT is set to "yes"

3.	After typing ifup eth0, I get...  Delaying eth0 initialization
	messages says...  localhost insmod:
/lib/modules/2.2.12-20/net/eepro100.0: init_module: device or resource busy

I'm stumped

Kanchana

-----Original Message-----
From: Henri J. Schlereth [mailto:henris neandertal org]
Sent: Wednesday, May 24, 2000 1:07 PM
To: redhat-install-list redhat com
Subject: Re: Lost eth0 on Redhat 6.1


> 
> My machine no longer recognizes eth0.  I've tried using linuxconf and
> netconfig to reconfigure it, but it still does'nt get recognized at boot
up.
> When doing a ifconfig -a only lo shows up.  I checked all the hardware,
it's
> fine.  Could it be that the drivers for eth0 are corrupt???  The machine
was
> working fine until it was rebooted.  Any ideas???
> 
> Kanchana

1.) it could be hardware
2.) check to see if ONBOOT=yes is in ifcfg-eth0
3.) try a ifup eth0 and watch /var/log/messages



Henri



-- 
-------------------------------------------------------------
"Perfectly normal, perfectly healthy." Adam Carrola
-------------------------------------------------------------


-- 
To unsubscribe: mail redhat-install-list-request redhat com with
"unsubscribe" as the Subject.