RE: NIC Recognition

["Drew Hunt" <pinowudi yahoo com>]

Revision 4 card?

Compile and use the tulip.o and pci_scan.o drivers included on the driver
disk.  Have RH load the pci-scan first, then tulip.  Be warned, this will
seriously confuse your other tulip cards if you have any.

Drew

> -----Original Message-----
> From: redhat-install-list-admin redhat com
> [mailto:redhat-install-list-admin redhat com]On Behalf Of Stephen Tenhet
> Sent: Monday, April 16, 2001 8:52 PM
> To: redhat-install-list redhat com
> Subject: NIC Recognition
>
>
> Running Redhat 7.0
>
>
> I had a problem with a D-Link DFE-550Tx nic card, so I removed it.
>
> I installed a Linksys LNE100TX card. This card is supposedly supported
> by the tulip.o file. I configured everything, but continue to get
> startup messages indicating the card is not being activated.
> Specifically insmod failure and the hing that the IO or IRQ may not be
> set properly. This is a pci card.
>
> I really need some help getting the network card setup. Any ideas would
> be appreciated.
>
> Thanks.
>
>
>
> _______________________________________________
> Redhat-install-list mailing list
> Redhat-install-list redhat com
> https://listman.redhat.com/mailman/listinfo/redhat-install-list