Re: LNE100TX 2

I tried installing the RPM only to be hit with a series of errors claiming that there were conflicts with the Kernel and it didn't install. I did it again, and forced it to install. Now at boot up it doesn't tell me that eth0 failed, it just doesn't mention it at all. Previous to this I have tried compiling all the proper files to make the new tulip.o and pci-scan.o, but when I ran the make command, it quickly listed errors and proceeded only to construct pci-scan.o. I thought I might have had a bad install, so I reinstalled it, but the same problems happened time and time again.

I am running a Compaq Athlon 500, dual boot with RH7.0 and Windows 2000, on separate Harddrives. Here is my listing from lspci

00:00.0 Host bridge: Advanced Micro Devices [AMD] AMD-751 [Irongate] System Controller (rev 23)

00:01.0 PCI bridge: Advanced Micro Devices [AMD] AMD-751 [Irongate] AGP Bridge (rev 01)

00:03.0 Multimedia audio controller: Ensoniq ES1371 [AudioPCI-97] (rev 08)

00:06.0 Ethernet controller: Bridgecom, Inc: Unknown device 0985 (rev 11)

00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super] (rev 14)

00:07.1 IDE interface: VIA Technologies, Inc. VT82C586 IDE [Apollo] (rev 06)

00:07.2 USB Controller: VIA Technologies, Inc. VT82C586B USB (rev 06)

00:07.3 USB Controller: VIA Technologies, Inc. VT82C586B USB (rev 06)

00:07.4 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 10)00:09.0 Communication controller: CONEXANT 56K Winmodem (rev 08)

00:0c.0 FireWire (IEEE 1394): Texas Instruments TSB12LV23 OHCI Compliant IEEE-1394 Controller

01:05.0 VGA compatible controller: 3Dfx Interactive, Inc. Voodoo 3 (rev 01)

I am truly out of ideas.

Thanks much,

Dan