Set up of a internet connection ethernet card&Alcatel modem

[WILLY OPDEKAMP <WILLY OPDEKAMP scania com>]

--- Received from SSS.BTOWOP +32-89 850123         01-07-31 12.23

Willy Opdekamp (yuc60982)
</WebX?224 136 PeBUa2pVKj5^1@295d  ee73d21> - 08:56am Jul 29, 2001
EDT

When trying to set up and internetconnection according the
hardware stated in the title and this with linuxcfg I receive the
following messages:
with pressing 'Accept', after filling in the necessary ISP data
gives RH the following message: "The state of the system is not in
sync. with the current/upgrade config.. You're allowed to make it
current.
If I asked which actions he says 'executing > /sbin/lilo'. I
'force' the config by selecting 'activate the > changes' and
receive the foolwing error <knip> > checking lilo > executing
/sbin/lilo > * fatal eror: sector 20869468 too large for linear
mode (try 'lba32' > instead) * return 1 > Executing some sysv.init
scriptb</knip> > > If I the perform teh action
/etc/rc.d.init.d/network stop (results-->shutting > down interface
eth0), next > /etc/rc.d.init.d/network start--> > -setting network
parameter [OK] > -bringing up interface lo [OK] > -bringing up
interface eth0 ---->> Determining IP info for eth0 operation >
failed. > > If I start up adsl-start I recieved the statement
...... > TIMED OUT >
The lspci for this ethernet card gives:
1) Ethernet controller:Realtek Semiconductor Co. Ltd. RTL-8139 rev
10, Subsystem: Accton Technology Coorporation: unknown devic ec01
Control:
I/O+Mem+Busmaster+SpecCycle-MemWINV-VGASnoop-ParrErr-Stepp..
Status:
Cap+66Mhz-UDF-FastB2B+ParErr-DEVSEL=medium>Tabort->TAbort-..
Latency: 32 (800 ns min, 16000 ns max) Interrupt: pin A routed to
IRQ 11 Region O:I/O ports at ec00 Region 1: Memory at d9000000
(32-bit, non-prefetchable) Capabilities [50] Power management
version 2 Flags: PMEClk-DSI-D1+D2+Auxcurrent=375 mA
PME(Do-,D1+,D2+,D3ho.. Status: DO PME_Enable+DSel=0 PME-
Capabilities:[60] Vital Product Data
2) I can't ping 10.0.0.138.!
The card is a LevelOne FNC-0109TX 10/100 Mbps. On the box is
saying
"driver support: .../... SCO Unix 4.x/5.x .../..."
Can someone help me out please,
tnx

---- 01-07-31 12.23 ---- Sent to       ---------------------------
  -> redhat-install-list(a)redhat.com