i ve 2 ethernet cards in my RH7.2 sys.
ethtool -i eth0 shows the status for 3com card,
[RH7.2]# ethtool -i eth0
driver: 3c59x
version: LK1.1.16
firmware-version:
bus-info: 01:0c.0
but for the second card which is from realtek, it says
[RH7.2]# ethtool -i eth1
Cannot get current device settings: Bad address
this second card is working fine, no problems.
there is corresponding entry in modules.conf file as well.
lsmod shows it to be loaded, but still ethtool doesnt seem to work.
any help with this regard will be appreciated.
Best regards,
abhi
**************************Disclaimer************************************************** Information contained in this E-MAIL being proprietary to Wipro Limited is 'privileged' and 'confidential' and intended for use only by the individual or entity to which it is addressed. You are notified that any use, copying or dissemination of the information contained in the E-MAIL in any manner whatsoever is strictly prohibited. ****************************************************************************************