RE: Two network cards both assigned eth0

["Waldher, Travis R" <Travis R Waldher boeing com>]

> -----Original Message-----
> From: Andrea Manica [mailto:manica_andrea hotmail com]
> Sent: Tuesday, September 02, 2003 11:03 AM
> To: Redhat-install-list redhat com
> Subject: Two network cards both assigned eth0
> 
> I am slightly puzzled. I installed RH9 2.4.20-8 on my desktop, and the
> network cards don't want to play. I have both a Gigabit 82545 EM on
the
> motherboard and an Intel ProS 100card in one of the PCI slots. Both
cards
> were assigned eth0 on install, and I don't seem to be able to change
that.
> Only the ProS works, but the onboad NIC doesn't. If I use the network
> config
> tool in red hat, it simply keeps the two cards on eth0 (both defined
as
> OK)
> and adds an phantom eth1 (which is defined "configured" rather than
OK).
> If
> I try to use eth1 card on any profile, I am told at boot up that the
card
> is
> not set up. Trying to play with modules.conf didn't help. Can anyone
offer
> some wisdom?
> Thanks
> 

can you post a copy of your modules.conf file here?