Changing SCSI Controllers - VFS errors

["Waldher, Travis R" <Travis R Waldher boeing com>]

Ok, I went from a Compaq 3200 Array controller the system was built with
to a 5300 controller.

The drivers that are used are different, no big, stuck the 5300 WITH the
3200 so it would boot and kudzu saw it, I told it to install, and all
seemed good.

The device paths changed, but I think I fixed that.  What don't think is
happening is the 5300 drivers are loading at boot so the system CAN get
to the drivers.

Will I need to rebuild a initrd image in order to boot?  If so, are
there any special steps I need to take?

Thanks,
Travis