Re: eth0 poblem

[HongMingJian <superhaar 263 net>]

On Thu, 31 May 2001, Prasanta Sen wrote:

> Hi friends
> only two pcs connected with a cascaded utp connection. one is only win95
> another is win98+linux. win95-win98 is comunicating fine. but when i run
> RH7.0 and configure eth0, after restarting all communications fails. in
> windows nics are found intact with their i/o, irq etc., and no error
> messages. even changing their protocols to NETBUI, they are lame.
> in win98+linux pc, i/o and irqs are showing as follows
> windows  i/o=c000-c01f   irq=11
> linux    i/o=5940-595f   and no irq
> Advance THANKS to helper(s)
> PS
>
>
>
> _______________________________________________
> Redhat-list mailing list
> Redhat-list redhat com
> https://listman.redhat.com/mailman/listinfo/redhat-list
>

My eth0 and soundcard (both isa) had the similar problem before.
If I boot linux by lilo, it always compliants "resource busy" or "...not
found".

It's my solutions:
0. Config conf.modules or modules.conf,
1. Get loadlin and install,

Every time I will go to linux(I have linux + win95):

2. Boot into msdos before into linux,
3. Initialize eth0 and soundcard in msdos,
4. Booting linux by loadlin, then everything is ok.

Hope this help.

--
HongMingJian, ChongQing, China
Tel. +86 (023) 65108319
superhaar 263 net
77555279
--