[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: enabling dual processor in redhat 7.3



Okay the easiest way that I can think of is if you boot and you are using GRUB then the it will say 2.4.xxx-smp somewhere, but realize that if you were using only one processor previously then it would be the case that you have a non-smp kernel since you added the processor later. So you may have to get to your RedHat disk and locate the kernel on that disk that says smp install it and up2date it as I am sure there must be a kernel update to that one.

jhun bacala wrote:
I'm a newbie in Linux, may I ask how do i know if I'm using the smp kernel?


At 12:01 PM 8/2/02, you wrote:


The question is that are you using an smp kernel ? If not then you will have to install the smp kernel rpms. Secondly you can use the program xosview to see the load on the two processors this will tell you whether Linux sees the 2 processors.

--
Aly Dharshi
aly dharshi uleth ca
System Administrator ORS Servers

        "A good speech is like a good dress
        that's short enough to be interesting
        and long enough to cover the subject"



--
redhat-list mailing list
Unsubscribe mailto:redhat-list-request redhat com?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list




--- Incoming mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.380 / Virus Database: 213 - Release Date: 7/24/02


------------------------------------------------------------------------


--- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.380 / Virus Database: 213 - Release Date: 7/24/02


--
Aly Dharshi
aly dharshi uleth ca
System Administrator ORS Servers

	"A good speech is like a good dress
	that's short enough to be interesting
	and long enough to cover the subject"





[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]