Re: Forcing 100Mbps Full Duplex

["Jason Riedel" <jasonriedel jasonriedel com>]

Michael,

    If the application doesn't provide a config, which is loads on boot.
Then the best thing to do would be to add to your /etc/rc.d/rc.local. This
will then run whatever commands are in there on boot.

mii-tool -F 100baseTx-FD

Someone else might have something slicker. Good Luck!

Thanks,
Jason Riedel
----- Original Message ----- 
From: "Michael Mansour" <micoots yahoo com>
To: <redhat-list redhat com>
Sent: Tuesday, April 29, 2003 5:48 PM
Subject: Forcing 100Mbps Full Duplex


> Hi,
>
> I have 2 Red Hat 8 machines, one of them containing an
> eepro100 and the other a 3c59x.
>
> I need to set both of the cards to 100Mbps full
> duplex, and use the mii-tool utility to do this via
> the command:
>
> mii-tool -F 100baseTx-FD
>
> However, when I reboot the setting goes back to
> Autonegotiate, which means it will autoneg at 100Mbps
> Half duplex.
>
> How can I fix this permanently so each boot makes it
> come up 100Mbps full?
>
> Thanks.
>
> Michael.
>
>
> __________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> http://search.yahoo.com
>
>
>
> -- 
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request redhat com?subject=unsubscribe
> https://listman.redhat.com/mailman/listinfo/redhat-list