Trouble installing network card

["Ernest Ellingson" <erne powernav com>]

I have a 3Com Etherlink III 3c5905TP which is causing a lot of
headaches.

I have re-installed RH Linux 7.1
During its original installation this card worked fine.

On the new install, the card isn't recognized by the install program.

I booted up in plain DOS and used 3Com's auto configure routine.
I tested the card and it passed all the tests.
Using the auto config the card was set to IO address 300h
The IRQ was set to 10

I ran linuxconf to configure the card.

I set it's IP address
And set the IO address to 300 and IRQ to 10
I set the kernel module to 3c509 from the drop down box.
Saved the configuration and did a /etc/rc3.d/S10network reload
The card failed.

On boot eth0 fails with an insmod bad parameter.

Does anyone have a clue about what is failing?  How do I find out what
parameter is bad.

Ernie