Re: Problems booting the install CD

[akonstam trinity edu]

On Tue, Feb 08, 2005 at 12:23:27PM -0800, Kam Leo wrote:
> On Tue, 8 Feb 2005 11:53:18 -0500 (EST), Steven W. Orr
> <steveo syslang net> wrote:
> > 
> > Aaron, this sounds promising. I have a Tyan K7 Thunder motherboard which
> > has a pair of Adaptec 7899W controllers. The bootable disc is hooked up to
> > one of the two contollers. In addition, there's an IDE drive that's hooked
> > up to the builtin IDE controller. The BIOS is config'd to boot off of
> > SCSI. Do I need to do anything to tell the CDROM to boot off of SCSI?
> > 
> > --
> 
> If an IDE drive is installed the code in my Adaptec SCSI controllers
> would not load its BIOS.  So the solution for you may be to install
> GRUB in the MBR of the IDE drive.
> 
The above is true but that is not the problem that he has. He can't get
the distribution installed. Grub does not show up until after the
install.
-- 

=======================================================================
Remember -- only 10% of anything can be in the top 10%.
-------------------------------------------
Aaron Konstam
Computer Science
Trinity University
One Trinity Place.
San Antonio, TX 78212-7200

telephone: (210)-999-7484
email:akonstam trinity edu