Re: [rhn-users] USB Sandisk memory stick not recognized

[Yasushi Okubo <yasushi cabm rutgers edu>]

In my case, it did not work with USB2.0 card, but worked with USB1.1 
card/port.
Try following steps:

Check no device is already mounted on /dev/sd*
Remove ehci-hcd module if it is loaded
Reinstall  usb-storage

Good luck,
yasushi

Note:
I do not think the following step is necessary, but....
If  your flash disk is still not found, run  rescan-scsi-bus.sh [you can 
get it from the following site]
http://www.linux1394.org/faq.php

Hector Sepulveda wrote:

> Hi,
>
> I have a 128 M Sandisk USB memory stick and I can't make it work in RHEL AS 3.0
> The system has two HD so is not about mounting it on /dev/sda1/
> To make things more confusing, a friend had no problems using his Cruzer mini
> USB memory stick in this same machine (mounting at /dev/sde1 ) and the Sandisk
> memory stick mounts well on a system with Fedora 3.0.
>
> dmesg shows the following:
>
> sde : status = 1, message = 00, host = 0, driver = 08
> Info fld=0xa00 (nonstd), Current sd00:00: sense key Not Ready
> sde : block size assumed to be 512 bytes, disk size 1GB.
> sde: test WP failed, assume Write Enabled
> sde: I/O error: dev 08:40, sector 0
> I/O error: dev 08:40, sector 0
> unable to read partition table
>
> Any hint?
>
> Thanx,
>
> Andres
>
> _______________________________________________
> rhn-users mailing list
> rhn-users redhat com
> https://www.redhat.com/mailman/listinfo/rhn-users
>