Swapping eth0 and eth1 designations

["Rodolfo J. Paiz" <rpaiz simpaticus com>]

Hi!

I have just acquired an old Dell P166 desktop to use as a firewall, and it 
had a 3Com 3c905 on board. It was detected using the 3c59x module and 
worked without a problem. I have now added a second 3Com 3c905 network card 
(PCI) to the system, and it appears that this one is also working perfectly.

However, the new add-in card is now eth0 and the onboard network is eth1. 
Just out of sheer idle curiosity, is there a way I can swap those two so 
that the onboard is eth0 and the add-in is eth1?


--
Rodolfo J. Paiz
rpaiz simpaticus com