Re: Swapping eth0 and eth1 designations

[Emmanuel Seyman <seyman wanadoo fr>]

On Sun, Nov 02, 2003 at 11:44:32AM -0600, Rodolfo J. Paiz wrote:
> 
> However, the new add-in card is now eth0 and the onboard network is eth1. 
> Just out of sheer idle curiosity, is there a way I can swap those two so 
> that the onboard is eth0 and the add-in is eth1?

If they're both using the same module, you have to swap them physically.
IIRC, the kernel goes through the PCI slotys from top to bottom.

Emmanuel