Re: Swapping eth0 and eth1 designations

["Rodolfo J. Paiz" <rpaiz simpaticus com>]

At 03:51 11/3/2003, you wrote:
> On Sun, Nov 02, 2003 at 11:44:32AM -0600, Rodolfo J. Paiz wrote:
> >
> > However, the new add-in card is now eth0 and the onboard network is eth1.
> > Just out of sheer idle curiosity, is there a way I can swap those two so
> > that the onboard is eth0 and the add-in is eth1?
>
> If they're both using the same module, you have to swap them physically.
> IIRC, the kernel goes through the PCI slotys from top to bottom.

But since one is physically /on the motherboard/, swapping them is (at 
best) difficult. I guess I'll simply label them on the back of the box and 
get used to it. Thanks!


--
Rodolfo J. Paiz
rpaiz simpaticus com