How to take precedence to libata (sata_sil) over siimage

[Milan Keršláger <milan kerslager pslib cz>]

Hi,

I see sata_sil module inside new U3 kernel 2.4.21-20.EL but there is a
problem with built-in siimage driver for my Sil 3112 PCI card.

Is there a way how to disable siimage inicialization or I have to
recompile the kernel?

When I plug SATA Sil card into the computer, it takes hda and hdc
position and all other interfaceas are moved after them:

Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SiI3112 Serial ATA: IDE controller at PCI slot 00:07.0
SiI3112 Serial ATA: chipset revision 2
SiI3112 Serial ATA: not 100% native mode: will probe irqs later
    ide0: MMIO-DMA , BIOS settings: hda:pio, hdb:pio
    ide1: MMIO-DMA , BIOS settings: hdc:pio, hdd:pio
VP_IDE: IDE controller at PCI slot 00:0f.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci00:0f.1
    ide2: BM-DMA at 0xcc00-0xcc07, BIOS settings: hde:DMA, hdf:DMA
    ide3: BM-DMA at 0xcc08-0xcc0f, BIOS settings: hdg:DMA, hdh:DMA
hda: no response (status = 0xfe)
hdc: ST3160023AS, ATA DISK drive
hde: ST380011A, ATA DISK drive
hdf: WDC WD400EB-00CPF0, ATA DISK drive
hdg: WDC WD1200JB-00CRA1, ATA DISK drive
hdh: ST3120026A, ATA DISK drive
ide1 at 0xffffff00000150c0-0xffffff00000150c7,0xffffff00000150ca on irq 18
ide2 at 0x1f0-0x1f7,0x3f6 on irq 14
ide3 at 0x170-0x177,0x376 on irq 15


I already made initrd image with libata, sata_sil and scsi_mod module
but the drive already appear as IDE drive...

I tryed to play with hdc=??? and ide1=?? with no luck.


-- 
                        Milan Kerslager
                        E-mail: milan kerslager pslib cz
                        WWW:    http://www.pslib.cz/ke/